Allows quick and easy testing with built-in 25W 5.4 ohm load to generate steady outputs.
Testing Procedures:
- Unplug any devices that are connected to the power supply
- Unplug the 20-pin ATX connector from the motherboard
- Plug the tester into the power supply's 20-pin ATX connector
- If the POWER_OK LED lights up, the power supply is working
To Measure Voltages with the Tester: A Volt
Meter Is Required
- Turn the volt meter dial to VDC
- Insert the black (-) pole to the COM lead and red (+) pole to the +5V lead as indicated on the diagram to read the voltage reading of the +5V
- Keep the black pole at the COM position, change the red pole to +3.3V or +12V to measure the voltages
|